1978 FORD F350 -- The driver"S side shoulder belt retractor mounting bracket assembly contains a weld nut which was improperly attached to the bracket. This fails to comply with the requirements of Federal Motor Vehicle Safety Standard no. 210, "Seat Belt Assembly Anchorages".

The dealer will repair the left side shoulder belt retractor mounting bracket on the involved vehicles free of charge. For detailed information & supporting documents, see the official NHTSA page concerning recall #78V168000 »

1978 FORD F350 -- These vehicles may be equipped with steering linkages on which cotter pins may not have been installed on castellated nuts to secure the steering drag link and tie-rod connections. Also, these attaching nuts may not have been tightened to specifications. This could allow linkage separation.

The dealer will perform necessary corrections to the steering linkage attachments. For detailed information & supporting documents, see the official NHTSA page concerning recall #78V109000 »

1978 FORD F350 -- The shift selector reaction springs may be deformed as a result of improper installation of selector levers during column buildup. Thus the lever may not be able to be moved into the insert detents located in the steering column assembly. This could prevent the "park" gear from being engaged.

Dealer will inspect and, if necessary, replace the shift selector reaction spring without charge to owner. For detailed information & supporting documents, see the official NHTSA page concerning recall #78V035000 »

1978 FORD F350 -- The wheel rim diameters on these vehicles may exceed dimensional specifications. This may cause the tires and tubes to be overstressed during mounting or improperly mounted.

The dealer will inspect and, if necessary, replace the wheels, and the tires and tubes mounted on these wheels. For detailed information & supporting documents, see the official NHTSA page concerning recall #78V024000 »

1978 FORD F350 -- The involved vehicles were built with aft-of-axle fuel tanks which were not authorized by light truck engineering. As a result, these vehicles fail to conform to Federal Motor Vehicle Safety Standard no. 301, "Fuel System Integrity", due to possible fuel tank leakage when impacted from the rear.

Dealer will inspect and replace aft-of-axle fuel tank with the correct tank, without charge to owner. For detailed information & supporting documents, see the official NHTSA page concerning recall #77V222000 »

1978 FORD F350 -- On the involved vehicles, leakage may occur at the threaded carburetor-to-fuel filter connection on the suspect carburetors. This is due to an improperly machined carburetor fuel inlet connection.

Dealer will inspect and, if necessary, will replace the carburetor without charge to owner. For detailed information & supporting documents, see the official NHTSA page concerning recall #77V198000 »

1978 FORD F350 -- On the involved vehicles, the park actuation support plates are defective due to their susceptibility to cracking due to improper heat treatment during manufacture. As a result, fragments from a broken plate can become lodged in the transmission parking pawl mechanism. This could prevent the transmission parking pawl from engaging when the selector lever is placed in the "park" position, or prevent the pawl from being disengaged from the park gear.

The dealer will replace the park actuation cam support plates, free of charge, on all affected vehicles. For detailed information & supporting documents, see the official NHTSA page concerning recall #77V185000 »

1978 FORD F350 -- The pitman arm to steering gear attachment nuts may not have been properly tightened on the involved vehicles. The nut could come off during vehicle operation.

Dealer will tighten the pitman arm attaching nut to the correct specifications without charge to owner. For detailed information & supporting documents, see the official NHTSA page concerning recall #77V169000 »

1978 FORD F350 -- Some of the involved vehicles may have defective carburetors in which, under certain circumstances, the secondary throttle plates may stick open.

Dealer will inspect and, if necessary, replace the carburetor at no charge to owner. For detailed information & supporting documents, see the official NHTSA page concerning recall #77V161000 »