1980 FORD BRONCO -- Intercontinental auto parts is recalling 1,937 fuel filters, P/nos alg 44/1 and purolator F10024, shipped between January 14 and February 13, 2008, sold for use on the vehicles listed above. The filter's outlet cap may not be securely crimped to the housing. This could result in a separation of filter's outlet cap from the housing.

If this condition occurs while attempting to start the vehicle, a no start condition may result and fuel may be pumped onto the ground. If this occurs while the vehicle is in motion, the engine may stop due to inadequate fuel supply. If an ignition source were present, fuel leakage may result in a fire.

Intercontinental will replace the fuel filters free of charge. The recall is expected to begin during March 2008. Owners may contact Intercontinental at 800-451-2593. For detailed information & supporting documents, see the official NHTSA page concerning recall #08E019000 »

1980 FORD BRONCO -- Certain federal-mogul aftermarket fuel pumps sold under the brand names of carter, accuflow, Napa, truflow, parts depo, and parts master, shipped between August 2006 and July 2007 for use on the vehicles listed above. The fuel pump diaphragm in certain production runs may have been improperly installed or inadequately tested which may cause the fuel pump to leak.

A leaking fuel pump could create a vehicle fire hazard.

Federal-mogul will notify owners and replace the defective fuel pumps free of charge. The recall began on October 15, 2007. Owners can contact federal-mogul at 248-354-7700. For detailed information & supporting documents, see the official NHTSA page concerning recall #07E064000 »

1980 FORD BRONCO -- The parking pawl actuating rod in the transmission may have an insufficient or cracked weld. This can cause the park cam end to separate from the rod itself, preventing the parking pawl from engaging the parking gear when the selector is placed in the park position.

Dealer will replace the defective parking pawl actuating rod free of charge. For detailed information & supporting documents, see the official NHTSA page concerning recall #79V261000 »

1980 FORD BRONCO -- The involved vehicles may have been produced with rear axle shafts (right or left) that did not receive proper heat treatment of the bearing journals.

Dealer will inspect and, if necessary, replace both rear axle shafts at no cost to owner. For detailed information & supporting documents, see the official NHTSA page concerning recall #79V237000 »